An error in the control loop for the converter power electronics was detected.
Category Archives: Event Codes
Event 178 – Converter IGBT/MOSFET Driver Error
An error on the power switch (IGBT/MOSFET) or in the power switch driver electronic was detected.
Event 177 – Converter DC Precharge Voltage High
The measured DC precharge voltage (DC bus voltage) is higher than the expected or achievable system voltage. The converter may not be able to connect to such a voltage.
Event 176 – Converter DC Precharge Voltage Low
The measured DC precharge voltage (DC bus voltage) is below the expected or set precharge voltage. The converter may not be able to connecting to such a low voltage.
Event 175 – Converter DC Link Current Low
The measured DC link current on the power converter is too low or negative (reverse polarity).
Event 174 – Converter DC Link Voltage Low/Reverse
The measured DC link voltage on the power converter is too low or negative (reverse polarity).
SPN/FMI Diagnostic Trouble Codes
The Diagnostic Trouble Codes consisting of SPN (Suspect Parameter Number) and FMI (Failure Mode Identifier) delivers specific information about a faulty property of the Diesel Engine.
Event 144 – Malfunction Indicator Lamp (MIL)
Event from the ECU of the Diesel Engine: »Malfunction Indicator Lamp«.
Event 145 – Protection Lamp (PL)
Event from the ECU of the Diesel Engine: »Protection Lamp«.
Event 143 – Amber Warning Lamp (AWL)
Event from the ECU of the Diesel Engine: »Amber Warning Lamp«.