The Converter Control miss control input value that that is cyclical expected on the CAN bus or detects values outside the range.
Category Archives: Event Codes
Event 183 – DPF Regeneration inhibited
Event Description The Diesel Particulate Filter Regeneration is a self-cleaning process that occurs when soot builds up inside the Diesel Particulate Filter (DPF). »Regeneration inhibited« informs that the regeneration process has been inhibited via the fpControl panel. Elements of the Event page Device that triggers this event: Generator Control Unit Warning Yes Error No Safety instructions …
Event 184 – DPF Regeneration Active
The Converter Control miss control input value that that is cyclical expected on the CAN bus or detects values outside the range.
Event 125 – Total AC Power high
The total AC power is above its upper limit.
Event »no paired device«
The communication between the panel and the generator control is interrupted. The panel has lost the generator Control (“no paired device”). It does not recognize any generator control.
Event 166 – Redundant Emergency Stop
Redundant emergency shutdown.
Event 29 – Power contactor low
At this digital output the voltage drop is monitored. The voltage drop between the output for the load relay and ground is below its lower limit.
Event 253 – Manual Intervention (ext. System)
Manual intervention to the system which is controlled via an external system interface.
Event 181 – Converter Control Value Fail
The Converter Control miss control input value that that is cyclical expected on the CAN bus or detects values outside the range.
Event 180 – Converter AC Frequency Detection
The converter electronic detects a difference beetwen an expected or set frequency and a measured or calculated frequency.