fpControl is a control system for Fischer Panda inverter generators, asynchronous generators, VS generators and AGT DC generators.
Monthly Archives: August 2020
Datasheet »fpControl Generator Control – Servo«
The »fpControl Generator Control – Servo« (fpControl GC-S) is a Generator Control for Fischer Panda asynchronous generators, variable speed Generators, AGT DC generators and inverter synchronous generators.
Datasheet »fpControl Control Panel – Generator«
The »fpControl Control Panel – Generator« (fpControl CP-G) is intended for use on generators with xControl or fpControl system. It is the user interface of the control system and is used to operate and display system data. In addition, parameters can be set in the service area.
Datasheet »fpControl Connection Board – Generator«
The »fpControl Connection Board – Generator« (fpControl CB-G) acts as an interface and establishes the connection between the system components within the generator capsule and the external components.
Datasheet »fpControl CAN Interface – SAE J1939«
The »fpControl CAN Interface – SAE J1939« (fpControl CI-SAE J1939) manages the communication between the »fpCAN« and an external SAE J1939-CAN-BUS.
Datasheet »fpControl Measurement Unit – MU-3ph/DC«
The »fpControl Measurement Unit – MU-3ph / DC« is used for AC and DC generators.
Datasheet »fpControl Measurement Unit – MM-3«
The »fpControl Measurement Unit – MM-3« (fpControl MM-3) is intended for use on AC generators with xControl or fpControl system. The module measures the AC voltage in three phases, the frequency and three times the AC current.
fpControl CAN-Bus (fpCAN)
In the fpControl system, the fpCAN is used for the communication between the system components.
Event 168 – Bus #1 dead
No communication on the respective other side when using sync-module.
Event 169 – Start Request Denied
Start request denied.
